1. Before using the plug in mosquito lamp
, check whether the voltage and frequency are consistent with the product, and use the power socket that matches the product. The ground wire of the socket must be well grounded, then connect the lamp to the power supply, turn on the power switch. When the purple light in the tube is seen, the killing work begins.
2. Applicable area: indoor 50m2 ~ 60m2, outdoor 100m2. For the first time, it is best to close the doors, windows or screens at dusk. The user just turns off the lights and leaves the lamp on for 2 to 3 hours. During the summer or when mosquitoes are active, they can be used every day to eliminate mosquitoes that slip into the room when the doors and windows are not tight.
3. After being used for a period of time, when the base below the luminaire is stacked with many mosquitoes and debris, it should be cleaned up in time. When cleaning, you must first cut off the power supply, next, take the insulated part of the screwdriver, use the metal rod of the screwdriver to disconnect and discharge the two network cables between the power grids. Then, press the outer net with two thumbs, taken out the rear net. Finally, the chassis is taken out for cleaning.
4. When cleaning the plug in mosquito lamp
, be sure to cut off the power and discharge the high voltage power grid with a screwdriver. When discharging, you must take the insulated part of the screwdriver to prevent electric shock.
5. Plug in mosquito lamps
will generate electric sparks during work. Therefore, they are strictly prohibited in places where there is a lot of dust and the possibility of burning or explosion, so as to avoid accidents.