The electronic rodent zapper
has a circuit protection function and can be grounded for a long time. (Traditional mousetraps burn out as soon as they are grounded.) without burn the machine. It is the latest modern electronic rodent zapper. It can stun the rats on the rodent line and catch live rats, at the same time, it has no harm to people, animals, etc. Widely used in warehouses, hotels, supermarkets, homes, aquaculture, food factories, pastoral vegetable fields, etc., it has the characteristics of quick effect, the large range of killing, convenient handling of dead rats, etc. Compared with cats, rat poisons, rat clips, squirrel cages and sticky mouse glue, it has its unique superiority. It can work continuously for a long time, its static power consumption is 8 watts, and the current is divided into six lines. It has a sound and light alarm and line display function. Its effective killing distance can reach 1000 meters. It is an efficient and widely used rodent control tools.
How to use the electronic rodent zapper
1. Wait: when the wiring is normal and the mouse has not touched the wiring:
Only the work light of the electronic rodent zapper
is illuminated without any alarm signal. You can use a rubber handle screwdriver (do not use a normal test pencil) to connect (short-circuit) the thin wire to the ground to see if there is current output, whether the alarm signal is normal, and whether the ground is wet enough.
2. Electric leakage: error alarm:
There is an alarm signal when the power is turned on, and there is no alarm signal when the output line is not connected. When viewing the rodent cable, there is no mouse touching the wire. You should carefully check whether the insulating hose on the bamboo stick has a dark leaking place (usually lightning). It can also be divided into several sections (10 meters), and each section is disconnected from the electricity, and then powered on to test the machine. Since the output current of this machine is very small, leakage will reduce the peak value of the output voltage and affect the rodent control effect.
3. Rodent control: working normally, there is a mouse touching the wiring:
When the mouse touched the thin wire, the machine will quickly release the high-voltage electrons, immediately stun the mouse, and stick it on the thin wire. At the same time, it will make a "beep..." sound, the light bulb will flash, the direction indicator will be lighted, noticing the host.
4. Dead Rat Treatment: The mouse touches the wire and dies on the thin wire:
On wet ground, if there are several dead mice that have not been cleared on the output line, it will affect the efficiency of rodent control in the later stage. If you clean up the dead mouse as soon as you see it, the effect of rodent control will be better.
First, connect the output line to the ground line (short circuit), then use a Phillips screwdriver to fine-tune the “alarm sound screw” on the bottom of the case, loosen counterclockwise first, then slowly clockwise to make the sound the best.
When using this electronic rodent zapper, be careful not to let the doors and windows open, otherwise, the mouse will easily escape. In addition, the launch port of the ultrasonic wave should be oriented as far as possible to a relatively spacious place, and the launch port should not be blocked by anything, or it would affect the efficiency of catching the mouse.